Master Forge BG2824BP-L Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS
4. Assemble Rear Beam.
4.1 Loosen 4-pc pre-assembled M6*16mm
Screws from Left Back Leg (W) and Right
Back Leg (G), leave the screw heads
protruding approximately 5mm.
4.2 Hang Rear Beam (O) onto Left & Right
Back Leg on the screws and only hand
tighten the screws at this point.
5. Assemble the front panel.
Loosen 8-pc pre-assembled M6*16mm
Screws from Left Front Leg (U) and Right
Front Leg (Q), leave the screw heads
protruding approximately 5mm.
6. Attach Front Panels (P) to the cart and
fasten the screws as shown. Then fully
tighten all the screws of rear beam at this
time.
4
W
5
Q
Q
6
P
P
Q
Q
10
O
U
U
P
P
U
U
P
P
G