Replacing Light Bulbs - Maytag Ice2O UKF8001AXX Guide D'utilisation Et D'entretien

Care and Cleaning

Replacing Light Bulbs

WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After
replacing light bulb, reconnect power.
CAUTION
To avoid personal injury or property damage,
observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Fresh Food Section
The fresh food light bulbs are located at the top of the
compartment and beneath the ice storage enclosure.
The freezer light bulb is located at the top front of the
freezer section.
Fresh Food Section Upper Front
1. Squeeze both sides
of light shield in the
open area while
pulling downward to
remove.
2. Remove light bulbs.
3. Replace with appliance
bulbs no greater than
40 watts.
4. Replace light bulb
shield by inserting
tabs on light shield
into liner holes on
each side of light
assembly.
Do not force shield
beyond locking point.
Doing so may damage light shield.
Fresh Food Left Rear Light
1. Press along upper edge of
light shield and roll light
shield foward to remove.
2. Remove light bulb. Replace
with appliance bulb no
greater than 40 watts.
3. Insert lower tabs of light shield into slots of fresh
food liner. Roll upward to snap into slots located
under the ice storage enclosure.
Freezer Light
1. Remove light bulb.
2. Replace bulb with
appliance bulb no greater
than 40 watts.
24