Other Connectors On The Front Panel - Rohde & Schwarz RTB2000 Consignes De Sécurité

®
R&S RTB2000
Risk of injury and instrument damage
The instrument is not rated for any measurement category. When measur-
ing in circuits with transient overvoltages of category II, III or IV circuits,
make sure that no such overvoltages reach the R&S RTB2000 input. There-
fore, use only probes that comply with DIN EN 61010-031. When measur-
ing in category II, III or IV circuits, always insert a probe that appropriately
reduces the voltage so that no transient overvoltages higher than
400 V (peak) are applied to the instrument. For detailed information, refer to
the documentation and safety information of the probe manufacturer.
Explanation: According to section AA.2.4 of EN 61010-2-030, measuring
circuits without any measurement category are intended for measurements
on circuits which are not connected to the mains system.
Logic probe (6)
The connectors for logic channels can be used if the Mixed Signal Option
R&S RTB-B1 is installed. The option provides connectors for two logical probes
with 8 digital channels each (D0 to D7 and D8 to D15).
The maximum input voltage is 40 V (peak) at 100 kΩ input impedance. The maxi-
mum input frequency for a signal with the minimum input voltage swing and
medium hysteresis of 800 mV (Vpp) is 300 MHz.
3.1.2

Other Connectors on the Front Panel

PATTERN GENERATOR (7)
Connectors for the pattern generator P0, P1, P2, P3.
The "Demo 1" signal is intended for demonstration purposes.
Getting Started 1333.1605.02 ─ 02
Instrument Tour
Front Panel
17