Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
®
R&S
RTB2000
2.4
Replacing the Fuses
The instrument is protected by a fuse. You can find it on the rear panel between
the main power switch and AC power supply.
Type of fuse: Size 5x20 mm, 250V~, T2.5H (slow-blow), IEC60127-2/5
Shock hazard
Before replacing a fuse, make sure that the instrument is switched off and
disconnected from all power supplies. Always use fuses supplied by
Rohde & Schwarz as spare parts, or fuses of the same type and rating.
1. Pull the fuse holder out of its slot on the rear panel.
2. Exchange the fuse.
3. Insert the fuse holder carefully back in its slot until it latches.
Getting Started 1333.1605.02 ─ 02
Preparing for Use
Replacing the Fuses
14
Publicité
Table des Matières
