Connecting The Water Supply; Venting The Cartridge Tank - Dometic SANITATION CT4110 Instructions De Montage

CT4110, CTS4110
5.6

Connecting the water supply

A
NOTICE!
• The water supply is connected using a solenoid valve mounted in the
toilet housing (fig. f 1, page 12).
• The operating pressure (water pressure) of the solenoid valve should
not exceed 6 bar (87 PSI).
• The solenoid valve is damaged by excessive pressure.
➤ Attach the freshwater supply hose (fig. f 2, page 12).
➤ Perform a leak test.
5.7

Venting the cartridge tank

Service door SK4 and SK5
➤ In the niche floor, create an opening with a diameter of approx. 12 mm (fig. g,
page 12).
➤ Run the vent hose into this opening for discharge to the outside.
Service door SK5 (optional)
➤ Press the spray paint out of the inner frame of the door (fig. h, page 13).
➤ Install the door.
➤ Insert the hose of the vent into the integrated vent opening of the service door
and the cassette tank (fig. i, page 13).
EN
Installing the toilet
23