Greasing The Cassette Seal; Cleaning The Bayonet Fitting And Greasing The Bayonet Seal; Greasing The O-Ring Of The Cassette Vent - Dometic Saneo B Notice D'utilisation

SaneoB, SaneoC
Greasing the slider rods
➤ Spray the rods of the slider with silicone spray (fig. f, page 7).
Greasing the slider seal
➤ Grease the two seals in the lower section of the toilet bowl (fig. g, page 7).
7.3

Greasing the cassette seal

!
CAUTION!
When the slider is closed during cleaning or greasing, there is a risk of
crushing body parts.
➤ Remove the cassette tank and place it on a firm surface.
➤ Pull back the cover (fig. h 1, page 7) so that the seal is accessible.
➤ Evenly grease the cassette seal (fig. h 2, page 7) at the top with silicone-based
grease. In this way the cover remains movable.
➤ Close the cover (fig. i, page 8).
7.4 Cleaning the bayonet fitting and greasing the
bayonet seal
➤ Loosen the bayonet fitting on the cassette (fig. j, page 8). In the state upon
delivery and after extended use, the bayonet fitting can be loosened only with
difficulty.
➤ Clean the bayonet fitting (fig. k, page 8) completely. The fitting must be lifted
slightly at the back.
➤ Uniformly grease the bayonet seals (fig. l 2, 3, page 9) with silicone grease.
➤ Put the bayonet fitting back in place (fig. m, page 9).
7.5

Greasing the O-ring of the cassette vent

➤ Take the adapter (fig. n 1, page 9) off the cassette.
➤ Grease only the attached O-ring (fig. n 2, page 9) with silicone grease.
EN
Cleaning and maintenance
25