Installing Cts Model - Dometic SANITATION CT4110 Instructions De Montage

Installing the toilet
Installing the control and operating panel of the CT 4110 toilet
Install the control and operating panel in the wall in the immediate vicinity of the toilet
at an easily accessible location.
I
NOTE
Use the scale template to make the wall cutout (fig. a, page 9).
➤ Prepare an opening in the installation box for the control and operating panel
(fig. b, page 10).
➤ Connect the electrical cables to the connections of the control and operating
panel (chapter "Electrical connection" on page 24).
!
CAUTION!
There is a risk of injury due to the springs springing back!
➤ Press in the retaining springs of the control and operating panel and push it into
the wall cutout (fig. b, page 10).
➤ Follow the instructions in (chapter "Connecting the water supply" on page 23).
➤ Slide in the mobile tank cassette (fig. c, page 10).
5.5

Installing CTS model

The detached model CTS4110 has no integrated water tank and has a wall connec-
tion console. The control and operating panel is integrated in the wall connection
console.
Setting up toilet CTS4110
Set up the model with wall connection console directly against the room wall
(fig. d, page 11). A previously attached wall bracket is used to secure the toilet and
the wall bracket.
➤ Screw on the wall bracket, level, at a height of 651.5 mm (25.65 in.) (fig. e,
page 11).
➤ Put the entire toilet module into the desired position in front of the wall bracket.
➤ Lift the toilet and hook the housing into the wall bracket (fig. d, page 11).
➤ Tightly fasten the base plate with six bolts (fig. 8, page 8).
➤ Place the two covers over the fastening screws in the base plate (fig. 0, page 9).
➤ Slide in the mobile tank cassette (fig. c, page 10).
22
CT4110, CTS4110
EN