Installing Wheels - Balanced Body Allegro 2 Instructions D'utilisation

Figure E
B. INSTALL POST FOR LOOPS
1. Orient as shown in Figure F.
2. Attach using provided screws and hex wrench.
7/8"
Screws
Figure F
5/8" Alignment Screws
Extended
Leg
3/8 Flat washer
3/8" Lock Washer
5" Bolt
New Foot
Spacers from old foot
Screws and washers from old feet
Top of carriage (upholstered part)
SoftTouch rope
adjustment lever
Carriage Post for Loops
IV. INSTALLING THE WHEEL KITS
Kit includes wheel brackets for right and left legs and Allen
wrench for assembly purposes.
Transport wheel kits are available for the Allegro 2 in both
standard and extended leg configurations but they are not
interchangeable. Assembly for both versions is the same. Wheels
are usually attached at the foot end of the frame, but can be
installed on the head-end if needed. If wheels are installed on the
head end of the Reformer, it cannot be stored on end.
A. INSTALLING WHEELS
1. Move the footbar in the vertical position (for stability). Install
footbar locking pins.
2. If you have a hard floor, put a Pilates mat on the floor next to
the Reformer to protect the finish.
3. Grabbing the Reformer frame, turn the Reformer on its side
(on mat).
4. Remove the existing rubber foot using Allen wrench.
5. Install wheel bracket and foot as shown in Figure G below.
See Figure H for final configuration.
6. Repeat on second leg.
Figure G
Figure H (standard wheel kit shown)
Reformer Leg
Wheel bracket
Rubber foot
Bolts and washers
16