Balanced Body Allegro 2 Instructions D'utilisation page 11

F. ATTACH COTTON LOOPS TO ROPES
The ropes on the Allegro 2 come pre-installed. To install loops
on the ropes simply feed the rope through the padded loop ring,
around the big padded loop and pull tight as shown in Figure L.
For detailed information on how to use the Allegro 2's SoftTouch
rope adjustment system please refer to online videos.
1
3
Figure L
2
4
II. USING THE
EASYSET FOOTBAR
ADJUSTING FOOTBAR AND FOOTBAR POSITION
To adjust between footbar positions, disengage the footbar by
lifting in the directions shown in Figure M. When moving the
footbar, lift from the middle using hands or feet (you may need
to use both hands or both feet). Avoid jerking the footbar. Then
move to desired position. See Figure N for available footbar
positions. Note: Use Position 1 when jumpboard is installed.
Position 5 allows you to move the footbar along the entire frame
length.
IMPORTANT SAFETY TIP:
Firmly seat footbar into each position before use. A quick shake
will verify that it is fixed securely in place. Do not pull up on
the footbar during use. To do so could unseat it and cause
unexpected repositioning of footbar.
Figure M
Figure N
Position 5
10