Buckle Connection & Adjustment Instructions - Honeywell Miller 650T/UGK Manuel D'utilisation

4.5 Buckle Connection & Adjustment Instructions
Ensure straps are not
1
twisted. The loose end
webbing strap is for ad-
justment and must always
be located on the outside
(away from the user).
Ensure straps are not
1
twisted. The loose end of
webbing is for adjustment
and must always be
located on the outside
(away from the user).
1 Ensure straps are not twisted.
Insert webbing strap with
grommets through tongue
buckle from the underside.
Us er In stru ctio ns - Engli sh
Pass the buckle with center
2
bar under the square link.
Turn center bar buckle so
that the edges line up with
the slots in the square link.
Pull the center bar buckle
completely through and allow
it to fall into place on top of
the square link.
Push both halves of the
2
buckle together until you
hear a click. Tug on both
halves of the buckle to
make sure it is firmly
connected. Pull loose end of
strap to tighten adjustment
of the harness. Then slide
rigid keeper (if applicable)
up to buckle. Tuck excess
webbing into elastic
keepers.
To disconnect, push forward
3
on both release levers, then
pull buckle apart.
Pull strap through until snug.
2
Place buckle tongue through
appropriate grommet.
9
Pull loose end webbing
3
strap to tighten adjustment
of the harness. Then slide
rigid keeper (if applicable)
up to buckle. Tuck excess
webbing into elastic
keepers.
Grasp the loose end web-
1
bing strap and pull to tighten.
Tuck excess webbing into
elastic keepers.
To loosen, flip buckle over
2
to release friction grip and
push outward to allow web-
bing to pull through buckle.
Tuck excess webbing into
3
elastic keepers.