Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.0 General Requirements,
Warnings and Limitations
2.1 General Requirements
All warnings and instructions shall be provided
to authorized persons/users.
All authorized persons/users must
reference the regulations governing
occupational safety, as well as applicable
ANSI or CSA standards. Please refer
to product labeling for information on
CSA standards met by product.
Proper precautions should always be taken to
remove any obstructions, debris, material, or
other recognized hazards from the work area
that could cause injuries or interfere with the
operation of the system.
All equipment must be inspected before
each use according to the manufacturer's
instructions.
All equipment should be inspected by a
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
Equipment must not be altered in any
way. Repairs must be performed only by
the manufacturer, or persons or entities
authorized in writing by the manufacturer.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
discarded.
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have
a rescue plan and the means at hand to
implement it when using this equipment.
2.2 Warnings and Limitations
CAPACITY
Maximum capacity, including body weight,
clothing and tools, is 400 lbs. (181.4kg).*
Us er In stru ctio ns - Engli sh
Never use fall protection equipment for
purposes other than those for which it was
designed. Fall protection equipment should
never be used for towing or hoisting.
All synthetic material must be protected from
sources. The use of heat resistant materials is
recommended in these applications.
Environmental hazards should be considered
when selecting fall protection equipment.
Equipment must not be exposed to
environmental hazards and chemicals which
may produce a harmful effect. Polyester
should be used in certain chemical or acidic
environments.
Do not allow equipment to come in contact
with anything that will damage it including, but
not limited to, sharp, abrasive, rough or high-
temperature surfaces, welding, heat sources,
electrical hazards, or moving machinery.
Do not expose the equipment to any hazard
which it is not designed to withstand. Consult
the manufacturer in cases of doubt.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
surface.
Never remove product labels, which include
important warnings and information for the
authorized person/user.
4
*If the system is used by an employee having
a combined tool and body weight between 310
lbs. (140.6 kg) and 400 lbs. (181.4 kg), then the
employer must appropriately modify the criteria
and protocols to provide proper protection for such
heavier weights, or the system will not be deemed
to be in compliance with the requirements of OSHA
1926.502(d)(16). [ANSI capacity range is 130 lbs.-
310 lbs. (59kg-140,6kg).]
Publicité
Table des Matières
