Technical Data; Inserting The Battery - Hilti GX 2 Mode D'emploi Original

4 Technical data

4.1 Fastening tool
Weight (empty)
Application temperature, ambient temperature
Maximum fastener length
Fastener diameter
Compression stroke
Magazine capacity in strips of 10 nails (Magazine capac-
ity)
Maximum fastener driving frequency (Fasteners per hour)
5 Loading the fastening tool
5.1 Equipment required for driving nails
Nails are fed through the magazine in strip form (ready-to-use strips of nails).
5.2 Loading the magazine
1. Pull the nail pusher back until it engages.
2. Slide the nail strips into the magazine as far as they will go.
Note
Strips of short nails could be inadvertently inserted the wrong way round. With short nails, take
care to ensure that the tips of the nails point towards the nose of the tool.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
3. Release the nail pusher and guide it forward as far as it will go.
5.3 Inserting the gas can
1. If you are using a new gas can, remove the transport safety device. → page 7
2. Open the gas can compartment cover.
3. Push the gas can (with metering valve fitted) into the red adapter in the gas can compartment.
4. Close the gas can compartment cover.

5.4 Inserting the battery

1. Check that the contacts on the battery and on the fastening tool are undamaged and free from foreign
objects.
2. Fit the battery and make sure that it is heard to engage.
◁ Once the battery has been fitted, the charge status LEDs light for a short time.
CAUTION
A falling battery presents a hazard. If the battery is not secured correctly it may drop out and fall
while the work is in progress.
▶ Check that the battery is seated securely.
3. Check that the battery is securely seated in the fastening tool.
6 English
Printed: 11.09.2017 | Doc-Nr: PUB / 5373611 / 000 / 00
3.9 kg
(8.6 lb)
−10 ℃ ...45 ℃
(14 ℉ ...113 ℉)
39 mm
(1.5 in)
• 2.6 mm (0.10 in)
• 3.0 mm (0.12 in)
20 mm
(0.8 in)
1 ...4
1,200