Driving Nails - Hilti GX 2 Mode D'emploi Original

6 Driving nails

WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to
serious injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the tool against your hand or any other part of the body.
1. Check the fastener driving depth setting.
2. Bring the nosepiece of the fastening tool and the support leg into contact with the working surface.
3. Press the fastening tool against the working surface as far as it will go (until fully compressed).
4. Check that the fastener guide is perpendicular to the working surface.
5. Pull the safety trigger to drive a fastener.
Note
It is not possible to drive a fastener if the fastening tool is not pressed fully against the working
surface.
6. Lift the fastening tool completely away from the working surface after driving a fastener.
7. Remove the gas can ( → page 7) and battery ( → page 7) and empty the magazine ( → page 7) when
work with the fastening tool is finished or before leaving the tool unattended.
7 Unloading the fastening tool
7.1 Removing the battery
▶ Press both battery release buttons at the same time and pull the battery out of the fastening tool.
7.2 Removing the gas can
1. Open the gas can compartment.
2. Remove the gas can.
3. Close the gas can compartment.
7.3 Unloading the magazine
1. Pull the nail pusher back until it engages.
2. Remove all nail strips from the magazine.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
3. Release the nail pusher and guide it forward as far as it will go.
8 Optional operating steps
8.1 Removing the transport safety device from a new gas can
1. Lift the transport safety device, containing the metering valve, away from the gas can.
2. Remove the metering valve from the transport safety device.
3. Fit the metering valve onto the gas can, with the foremost of the two grooves on the lip of the can.
4. Press the metering valve firmly onto the gas can, bringing the rearmost groove towards the lip of the can,
until the metering valve is heard to snap into place over the lip and it then lies flush with the can.
8.2 Checking the status of the gas can
1. After inserting the battery, press the GAS button without pressing the fastening tool against the working
surface.
2. Read the gas can status from the display. → page 5
Printed: 11.09.2017 | Doc-Nr: PUB / 5373611 / 000 / 00
2
English 7