Hilti GX 2 Mode D'emploi Original page 12

8.3 Removing the magazine
1. Pull the nail pusher back until it engages.
Note
The magazine cannot be removed if the nail pusher has not been pulled back until it engages in
the rearmost position.
2. Remove the loose nail strips from the magazine.
3. Release the magazine locking catch.
4. Pivot the magazine about the pivot point towards the front.
5. Detach the magazine.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
6. Release the nail pusher and guide it forward as far as it will go.
8.4 Fitting the magazine
1. Pull the nail pusher back until it engages.
Note
The magazine cannot be fitted if the nail pusher has not been pulled back until it engages in the
rearmost position.
2. Engage the front end of the magazine with the fastening tool.
3. Pivot the magazine towards the fastening tool as far as it will go.
4. Close the magazine locking catch.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
5. Release the nail pusher and guide it forward as far as it will go.
8.5 Removing the fastener guide
1. Remove the battery. → page 7
2. Remove the gas can. → page 7
3. Unload the magazine. → page 7
4. Move the fastener guide release slider to the EJECT position.
5. Remove the fastener guide.
8.6 Inserting the fastener guide
1. Remove the gas can. → page 7
2. Remove the battery. → page 7
3. Unload the magazine. → page 7
4. Push the fastener guide release slider in the direction of the arrow into the EJECT position and hold it
there.
Note
The fastener guide can be inserted only when the slider is held in the EJECT position.
5. Slide the fastener guide into the slot in the nose of the fastening tool until it is heard to engage.
6. Check that the fastener guide is seated correctly.
8.7 Removing the support leg
1. Release the support leg engaging mechanism by pressing lightly.
2. Pivot the support leg until it can be withdrawn from the locating groove.
8 English
Printed: 11.09.2017 | Doc-Nr: PUB / 5373611 / 000 / 00