StealthCam STC-G34 Manuel D'instructions page 9

!
SETUP DATE – 01/01/15 (default): This setting is used to give the camera the correct date to
use on the Info Bar of the images. The format is in a MM/DD/YY setup. With the MM (month)
setting blinking, use the UP and DOWN arrows to be change the setting from 1 to 12. Once this
setting is on the appropriate month, press the RIGHT arrow key to move to the DD (day) setting
and it will start to blink. Using the UP and DOWN arrows will allow the setting to be change
from 1 to 31 based upon the MM that has previously set. Again when this setting is on the
appropriate day, press the RIGHT arrow key to move to the YY (year) setting and it will start to
blink. Using the UP and DOWN arrows will allow the setting to be changed from 14 to 35.
!
SETUP TIME – 12:00AM (default): This setting is used to give the camera the correct time to
use on the Info Bar of the images. By default it will be setup for Central Standard Time (CST).
The default format is in a HH/MM/AP setup. With the HH (hour) setting blinking, use the UP
and DOWN arrows to change from 1 to 12. Once this setting is on the appropriate hour, press
the RIGHT arrow key to move to the MM (minute) setting and it will start to blink. Using the
UP and DOWN arrows will allow the setting to be change from 00 to 59. Again when this
setting is on the appropriate minute, press the RIGHT arrow key to move to the AP (am/pm)
setting and it will start to blink. Using the UP and DOWN arrows will allow the setting to be
changed from AM to PM.
!
TIME ZONE – CST (default): This allows you to set your camera to different time zones. By
pressing the ENTER button and choosing between the following options below and pressing
Enter again, you will save your selection. Eastern, Central, Mountain, Pacific, Alaskan,
Hawaiian.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING – CUSTOM (CONT)
Page
9