StealthCam STC-G34 Manuel D'instructions page 13

o
TIME LAPSE (TL): In this mode the camera will take a designated amount of pictures with a
designated time out between the designated hours of operation even if there is no activity in
front of the camera.
"
PHOTO RES – 6.0MP (default): This setting is used to determine the Megapixel resolution of each image taken
by the camera. With this option blinking, use the UP or DOWN arrow key to move between the options of:
12.0MP, 8.0MP, 6.0MP, 2.0MP. The higher the resolution of an image the more space the file will take on the SD
memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With the TL mode this setting is only active if TL
Delay is set to 1 min or greater. This setting can be changed between the numbers of 00min 05sec to 59min
59sec. With this option blinking, use of the UP and DOWN arrows will allow the minutes setting to be changed
from 00 to 59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to the
seconds setting and it will start to blink. Use of the UP and DOWN arrows will allow the seconds setting to be
changed from 00 to 59 (05 to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will be
activated. These distances can vary depending on environmental conditions. This setting will change between
EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD setting, or NEAR
FIELD that will only trigger on movement closest to the camera.
"
TL DELAY – 00min 30sec (default): This setting is used to set a delay between TIME LAPSE images. This setting
can be changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP
and DOWN arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to blink. Use of
the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes = 0). If
the TL Delay is greater than or equal to 1 min, then the PIR sensor will be active between time-­‐lapse photos.
"
TL START – 06:00PM (default): This setting is used to give the camera the start time for when to start the time-­‐
lapse photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour the
format itwill show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN arrows to allow the
setting to be changed from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT arrow key to
move to the MM (minute) setting and it will start to blink.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
13