StealthCam STC-G34 Manuel D'instructions page 14

Using the UP and DOWN arrows will allow the setting to be change from 00 to 59. Again when this
setting is on the appropriate minute, press the RIGHT arrow key to move to the AP (am/pm) setting and
it will start to blink. Using the UP and DOWN arrows will allow the setting to be changed from AM to
PM.
"
TL STOP – 08:00AM (default): This setting is used to give the camera the stop time for when to end the
time-­‐lapse photography. The default format is in a HH/MM/AP setup, should the time format be in 24
hour the format will be HH/MM. With the HH (hour) setting to blinking, use the UP and DOWN arrows
to allow the setting to be changed from 1 to 12. Once this setting is on the appropriate hour, press the
RIGHT arrow key to move to the MM (minute) setting and it will start to blink. Using the UP and DOWN
arrows will allow the setting to be change from 00 to 59. Again when this setting is on the appropriate
minute, press the RIGHT arrow key to move to the AP (am/pm) setting and it will start to blink. Using
the UP and DOWN arrows will allow the setting to be changed from AM to PM.
"
REDUCE BLUR – ADVANCED (default): This is used to determine if the camera should use the MATRIX
Blur reduction technology to dramatically reduce the blur effect resulting in clearer night time infrared
shots. (STANDARD) Minimizes blurring effect in images whlle retaining long-­‐range night image
capability. (ADVANCED) Maximum blur reduction achieved through a faster shutter speed. This setting
my cause a slight reduction in night time range and increased grain in the image. With this option
blinking, pressing the UP or DOWN arrow buttons will cause the camera to cycle between the two
options of STANDARD or ADVANCED.
EXAMPLE: Data Stamping on the bottom portion of the picture indicates the camera took a picture in Time
Lapse (TL) mode.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
14