Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TEST – This is the final switch setting, and is used to test the camera's PIR sensor
coverage area. When moved to this setting the display will display:
The number listed at the bottom of the display shows the current version of the
firmware that is installed on the camera.
you have and the last four XX.XX indicates the firmware version. This is very important
information when performing an update.
any firmware updates are available.
When in this mode the Test Mode light will blink green when the camera detects motion.
This will help determine if the camera is positioned at a location that will sense motion as
it passes by causing the camera to activate in its PIR and video mode.
www.stealthcam.com
877-‐269-‐8490
CAMERA PROGRAMMING
TEST
VXX.XX.XX
Please check the Stealth Cam website to see if
Page
The first two XX indicates which model version
18
Publicité
Chapitres
Table des Matières
