StealthCam STC-G34 Manuel D'instructions page 11

o
PIR PHOTO (default): In this mode the camera will take a designated amount of picture with a
designated time out when the camera senses activity in front of the unit. This mode is available
for both day and night activities.
"
PHOTO RES – 6.0MP (default): This setting is used to determine the Megapixel resolution of each image
taken by the camera. With this option blinking, use the UP or DOWN arrow key to move between the
options of: 12.0MP, 8.0MP, 6.0MP, 2.0MP. The higher the resolution of an image the more space the
file will take on the SD memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this
setting is only active if TL Delay is set to 1 min or greater. This setting can be changed between the
numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN arrows
will allow the minutes setting to be changed from 00 to 59. Once this setting is on the appropriate
minutes, press the RIGHT arrow key to move to the seconds setting and it will start to blink. Use of the
UP and DOWN arrows will allow the seconds setting to be changed from 00 to 59 (05 to 59 if minutes =
00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will
be activated. These distances can vary depending on environmental conditions. This setting will change
between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD
setting, or NEAR FIELD that will only trigger on movement closest to the camera.
"
REDUCE BLUR – ADVANCED (default): This setting is used to determine if the camera should use the
MATRIX Blur reduction technology to dramatically reduce the blur effect resulting in clearer night time
infrared shots. (STANDARD) Minimizes blurring effect in images whlle retaining long-­‐range night image
capability. (ADVANCED) Maximum blur reduction achieved through a faster shutter speed. This setting
my cause a slight reduction in night time range and increased grain in the image. With this option
blinking, pressing the UP or DOWN arrow buttons will cause the camera to cycle between the two
options of STANDARD or ADVANCED.
"
PHOTO BURST – 1 PHOTO (default): This setting is used to determine the number of photos the camera
will take during its activation. This setting can be changed between 1 up to 9 PHOTOS. With this option
blinking, use the UP or DOWN arrow key to move between the value range in increments of 1.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
11