Battery Removal & Installation - StealthCam STC-G34 Manuel D'instructions

To remove the batteries from the unit; open the case
and press the EJECT button on the lower right hand
corner. This will cause the battery tray to be released
and slide downwards.
To reinsert the battery tray; position the tray so the base of the tray matches with the
opening at the bottom of the camera. The tray is notched so that incorrect insertion of
the battery tray is not possible. With the orientation correct simply slide the battery tray
into its final locked position. Should the battery tray not willingly slide into it destination,
remove the tray and examine the area of possible debris that may be causing the issue.
NOTE: Replacing the batteries will not reset the cameras current configurations.
Remove batteries from the tray if the unit will not be in use for extended period of time.
www.stealthcam.com
877-­‐269-­‐8490
BATTERY REMOVAL & INSTALLATION
New, Alkaline or Lithium, 'AA' batteries must be
inserted with the orientation as shown on the tray.
As with most electronic devices the negative (
orientation of the batteries should be against the
springs. Failure to insert the batteries properly will
cause damage to the unit.
**WARNING**
Do not mix new and old batteries.
Page
-­‐
)
22