StealthCam STC-G34 Manuel D'instructions page 16

!
LATITUDE – 000.000000N (default): This setting is used for the GEO-­‐TAG of the camera. It will
not be displayed on the images directly, but rather on the background image information. The
coordinates can be changed from 000.000000 to 179.999999 and either N (North) or S (South).
With this option blinking, use the UP or DOWN arrow buttons to change the initial number
blinking. Once the number is correct use the RIGHT arrow button to continue to the next
value. Repeat until the final desired numeric sequence is entered.
!
LONGITUDE – 000.000000E (default): This setting is used for the GEO-­‐TAG of the camera. It will
not be displayed on the images directly, but rather on the background image information. The
coordinates can be changed from 000.000000 to 179.999999 and either E (East) or W (West).
With this option blinking, use the UP or DOWN arrow buttons to change the initial number
blinking. Once the number is correct use the RIGHT arrow button to continue to the next
value. Repeat until the final desired numeric sequence is entered.
!
FACTORY RESET – NO (default): This setting is used to reset the camera to its factory defaults.
With this option blinking, pressing the UP or DOWN arrow buttons will cause the camera to
cycle between the two options of NO or YES. When the YES option is chosen and the ENTER
button is press the camera will default all configurations made up to this point.
!
SECURITY KEY – OFF (default): This setting allows the owner of the camera to program a four
(4) character alphanumeric code to keep unauthorized people from accessing their camera
settings. To turn this feature on press the ENTER button, then press the UP or DOWN arrow
buttons to change to the YES option. Once chosen, press the ENTER button and the camera
will now engage this feature. Pressing the DOWN arrow key will move to the security key
configuration.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
16