Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Custom – This is the fifth setting and is defined by the user. When the camera is changed to this
mode, the display screen will reflect the last program setting: Number of images on the memory
card, Countdown timer and Battery percentage.
The system default programming is set to 6.0MP resolution, 5-‐second timeout delay and 1 Photo
Burst. The 30-‐second timer on the lower left of the display will count down towards 0 showing how
much time is left to enter the Custom configuration mode. Should no change be made, the system
will give an additional 30 seconds for the operator to move out of the coverage area before the
camera becomes active.
To make changes to the programming, press the MENU button to enter the configuration menu
before the countdown reaches zero. When in the MENU configuration, pressing the DOWN arrow
button will move the configuration to the next setting option. Pressing the ENTER button on the
listed configuration option will cause the option to blink and allow it to be changed. Pressing ENTER
again once an option has been changed will set the new configuration, save it to the camera's
memory, and return to selection section of the MENU configuration. Once all the settings have been
changed to the operator's desired settings pressing the MENU button will return to the initial display
and the 30-‐second timer will start the countdown again. The following are the options and
descriptions of how to change the configuration:
www.stealthcam.com
877-‐269-‐8490
CAMERA PROGRAMMING – CUSTOM (CONT)
PHOTO
00:30
Page
00000
100%
8
Publicité
Chapitres
Table des Matières
