StealthCam STC-G34 Manuel D'instructions page 15

!
CAMERA NAME – STEALTH CAM (default): This setting is used to identify the camera on the
Info Bar. It can be up to 13 characters long in the form of alpha (A-­‐Z), numeric (0-­‐9), or spaces.
With this option blinking, use the UP or DOWN arrow buttons to change the initial character.
Once the blinking character has been changed, use the RIGHT arrow button to continue to the
next character. Repeat until the desired name is entered. When finished press the ENTER
button again to confirm and store the new camera name. Pressing the DOWN arrow key will
move the display to the next configuration option.
!
TEMPERATURE – FAHRENHEIT (default): This setting is used to tell camera if the temperature
reading on the Info Bar should be in Fahrenheit or Celsius. With this option blinking, pressing
the UP or DOWN arrow buttons will cause the camera to cycle between the two options.
!
INFO BAR – ON (default): This setting is used to tell the camera if the Info Bar should be
displayed at the bottom of images and video or not. With this option blinking, pressing the UP
or DOWN arrow buttons will cause the camera to cycle between the two options of ON or OFF.
!
DVR MODE – OFF (default): This setting allows you to perform loop recordings. When turned
ON, this mode will allow the camera to overwrite the earliest recorded files when the SD card
reaches full capacity. When turned OFF, the camera is not allowed to write over existing files.
Once SD card is full the camera stops recording.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
Page
15