Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Beginning on the driver side, remove plastic plugs or factory hex
Align running board brackets so that the slots in the
bolts (if equipped). Repeat for remaining mounting locations.
brackets align with the holes from Step 2. Partially
(Figure 1)
attach Front Mounting Bracket to the vehicle using (2)
8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm
Flat Washers. Do not fully tighten at this time. (Figure 2)
2
Figure 1
3
Figure 2
Repeat Step 3 for Center and Rear Mounting Bracket installation, (Figures 3 & 4).
4
Figure 3
Figure 4
Check boards for final position and tighten all hardware. Repeat Steps 1-5 for passenger side.
5
Figure 5
Page 2 of 3
Publicité
Table des Matières
