Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Align the Front Visor on the outside of the door frame. Push the front flange BETWEEN the plastic mirror cap and the outside of the door
NOTE: It may be necessary
to roll front window down and
use a putty knife to create a
gap in which to insert the front
flange.
3
Gently press the exposed areas of tape against the surface and
verify position. With the Front Visor in its final position, remove the
remaining tape liner by pulling on free end.
4
4 Piece Set
Peel back 2" (5cm) of tape liner from each end
of top flange. Remove tape liner from
front flange. Remove tape liner from rear flange
free end
top flange
6
rear flange
(remove tape liner) (remove tape liner)
Gently press the exposed areas of tape against the surface and
verify position. With the Rear Visor in its final position, remove the
remaining tape liner by pulling on free ends.
8
NOTE: Actual application may vary slightly from illustrations.
frame. The top flange of the Front Visor will attach to the door frame.
mirror cap
(6 piece set only).
free end
front flange
Apply pressure along all flanges to ensure proper adhesion of tape.
5
Align the deflector with the edge of front and rear doors.
align
7
Apply pressure along all flanges to ensure proper adhesion of tape.
9
Page 2 of 3
Publicité
Table des Matières
