Installation Steps; Care And Cleaning - LUND Ventvisor Elite Instructions D'installation

Installation Steps

Insert visor into window channel, rear flange first. Insert rear flange between rubber trim and door post. Insert
front flange between the rubber and the mirror cap. The top flange slides into the window channel.
3
Remove tape liner by pulling on free ends. Raise
window slowly and leave up for 24 hours to secure
visor to window channel.
4

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Repeat steps 1 thru 5 for passenger side
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2014 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
4 Piece Set
5
Page 2 of 2
Install the rear visors using the same
preparation and installation methods
as the front visor. Note that front & rear
flange fit between the rubber & post.