Installation Steps - LUND Interceptor 18832 Instructions De Montage

Installation Steps

Remove (4) plastic seal retaining fasteners that align with the pre-
drilled holes in the hood shield. Next, carefully separate the hood
seal / gasket from the areas of the hood that align with the hood
shield flange.
NOTE: Exercise extreme caution not to tear
3
or damage the hood seal / gasket when
seperating from hood.
Separate Fastener Assembly in two pieces. Gently pull back hood seal / gasket and place the female portion of fastener
through hood shield and into hood. Replace hood seal /gasket. Install male portion of fastener as illustrated.
5
Tighten all (4) fasteners until snug to secure
hood shield to hood.
6
8
NOTE: Actual application may vary slightly from illustrations.
Repeat for remaining (3) fasteners.
Center a piece of protective film over each grease pencil mark, and wrap around the hood edge.
Reposition the hood shield with the tabs sliding between the
hood and rubber seal and align with holes.
4
DO NOT OVER TIGHTEN
Note the location where the brackets will align with hood
7
Page 2 of 3
hood shield
fastener (female
hood seal /
fastener (male
edge and mark with a grease pencil.
portion)
gasket
portion)