Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Insert visor into window channel.
3
With the visor in its final position, remove the remain-
der of the tape liner by pulling on free ends.
5
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
7
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2015 Lund International, Inc. All rights reserved.
Lund
and the Lund
logo are trademarks of Lund International, Inc.
®
®
Press the exposed area of tape against the surface and
4
Apply pressure along the inside of window channel and
flange edges to secure in place.
6
4 Piece Set
as the front visor. Note that rear flange attaches to the
outside of the window post.
8
Repeat steps 1 thru 8 for passenger side
Page 2 of 2
verify position.
Install the rear visors using the same
preparation and installation methods
Publicité
Table des Matières
