Connection Of Water Hose To The Jug - Blomberg KQD1360X Manuel D'utilisation

Connection of Water Hose to
the Jug
(in some models)
To connect water to the refrigerator from
a jug, a pump is needed. Follow the
instructions below after connecting one
end of the water pipe coming out of the
pump to the refrigerator as described on
the previous page.
1. Finish the connection by pushing the
other end of the water pipe into the
water pipe inlet of the pump as shown
in the figure.
2. Put and fix the pump hose into the jug
as shown in the figure.
3. After completing the connection, plug in
and run the pump.
To provide an efficient operation of the
pump, wait for 2-3 minutes after
starting the pump.
C
You may refer to the user manual
of the pump while making the water
connection.
C
There is no need to use water filter in
case a jug is used.
C
Pump must be used when jug will be
used.
16
EN