Putting Out Of Operation - Binzel Abicor iROB Pulse 400 Mode D'emploi

iROB Pulse
1 Dummy cover connecting socket for
robot interface RI 1000/2000/3000
2 Dummy cover connecting socket for torch
cleaning station
Fig. 8 Rear view
Symbol Pos. Designation
(3) Connection (CAN BUS)
(5) Control lead connection intermediate cable assembly
(6) Positive connection for welding current
(7)
Negative connection for welding current (ground cable)

8 Putting out of operation

NOTICE
• Observe the operating instructions of the welding components, such as the coolant recirculator
1 Disconnect the robot welding power supply iROB Pulse from the mains on the main switch (6).
 Fig. 7 Front view on page EN-17
BAL.0323.0 • 2017-08-31
1
7
3 CAN bus
4 Connecting cable passage
5 Control lead connecting socket for
intermediate cable assembly
iROB Cool, wire feeder iROB Feed, remote control iROB Control and welding torch.
2 3
4
5
6
6 Positive connecting socket for welding current
7 Negative connecting socket for welding current
8 Putting out of operation
EN - 19