Identification; Safety; Designated Use En; Responsibilities Of The User En - Binzel Abicor iROB Pulse 400 Mode D'emploi

iROB Pulse

1 Identification

The iROB Pulse robot welding power source is a fully digitised robot power source for inert gas welding
in industry and in the trade. The robot power source fulfills the various requirements for operating in
automatic or robot mode.
The following versions are available:
• iROB Pulse 400, iROB Pulse 400 MV, iROB Pulse 500
Its modular design allows an individual mechanical and electronic adjustment via I/O or digital BUS
systems. The robot welding power source iROB Pulse may only be operated using original
ABICOR BINZEL spare parts.
These operating instructions only describe the robot welding power source iROB Pulse.
1.1 CE marking
This device fulfils the requirements of the relevant EU directives.

2 Safety

This chapter conveys significant information on safe operation of the product. Before using the system for the
first time, please read these operating instructions carefully and make sure that every user is familiar with the
contents of them.
• Before using the system for the first time, please read these operating instructions carefully. They provide
you with all the information you need for trouble-free and safe operation.
• Read and observe the operating instructions before carrying out specific work such as commissioning,
operation, transport and maintenance.
2.1 Designated use
• The device described in these instructions may be used only for the purpose described in these
instructions in the manner described. In doing so, observe the operating, maintenance and servicing
conditions.
• Any other use is considered contrary to the designated use.
• Unauthorized conversions or power increase modifications are not allowed.
2.2 Responsibilities of the user
• Keep the operating instructions within easy reach at the device for reference and enclose the operating
instructions when handing over the product.
• Putting into operation, operating and maintenance work may only be carried out by qualified
personnel. Qualified personnel are persons who, based on their special training, knowledge,
experience and due to their knowledge of the relevant standards, are able to assess the tasks assigned
to them and identify possible dangers (in Germany see TRBS 1203).
• Keep other persons out of the work area.
• Please observe the accident prevention regulations of the country in question.
• Ensure good lighting of the work area and keep the work area clean.
• Occupational health and safety regulations of the country in question. For example, Germany:
Occupational Health and Safety Act and Ordinance on Industrial Safety and Health
• Regulations on occupational safety and accident prevention.
• According to DIN EN 60974-10, this device is considered class A welding equipment. The class A
welding equipment is not intended for use in residential areas with a public low-voltage power supply
system. Such use can cause electromagnetic interferences that may result in machine damage and
malfunctions. Use the device only in industrial areas.
• The device conforms to EN/IEC 61000-3-11.
BAL.0323.0 • 2017-08-31
Conformity is confirmed by the CE marking on the device.
1 Identification
EN - 3