Binzel Abicor iROB Pulse 400 Mode D'emploi page 44

7 Operation
Symbol Pos. Designation
(1) Allows display of wire feeder speed, recommended material thickness, welding current.
(2) Lit when the robot welding system has been connected to the power supply and is on.
(3) The error message is shown on the digital displays.
 10 Troubleshooting on page EN-21
(4) Lit when voltage has been applied to the output terminals of the system.
(5) Switches the parameters in (1).
(6) Switches on the system. Has two positions: "O" OFF, "I" ON.
(7) Resets the error message when an alarm occurs.
(8) Connection for iROB Control.
(9) Voltage during welding/ error codes.
EN - 18
iROB Pulse
BAL.0323.0 • 2017-08-31