Binzel Abicor iROB Pulse 400 Mode D'emploi page 49

iROB Pulse
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. Observe the regulations on the disposal of electronic scrap and dispose of it at your local waste
disposal site (e.g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take note of the following
information:
 11 Dismounting on page EN-22
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter sewage systems. These materials
must be stored, transported and disposed of in suitable containers. Observe the relevant local regulations
and disposal instructions of the safety data sheets specified by the manufacturer of the consumables.
Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with the
information provided by the manufacturer of the consumables.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. Packaging materials
are always selected with regard to their possible recycling ability.
BAL.0323.0 • 2017-08-31
12 Disposal
EN - 23