Welding Process; Putting Out Of Operation; Maintenance And Cleaning; Electric Shock - Binzel Abicor ABIROB W Mode D'emploi

®
ABIROB W

7.1 Welding process

8 Putting out of operation

9 Maintenance and cleaning

NOTICE
• The welding torch may only be operated by qualified personnel.
• Ensure that all required parameters, for example welding current, wire
feed, etc., have been set at the welding power supply according to your
welding task.
1 Open the shielding gas cylinder.
2 Switch on the power supply.
1 Wait until the shielding gas flow has subsided.
2 Close the shut-off valve for the gas supply.
3 Switch off the power supply.
Scheduled maintenance and cleaning is prerequisite for a long life and a
trouble free operation.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Close off the compressed air supply.
• Pull the mains plug.
DANGER

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
8 Putting out of operation
EN - 17