Factory Settings; Technical Specifications - aqua metro aquadata M-Bus Instructions De Montage

Setting of parameters
If desired, the standard parameters (factory settings) of the aquadata
Knowledge of M-Bus is assumed for setting the module parameters.

Factory settings

• Primary address
• Secondary address
• Meter reading
• Medium
• Billing date
• Date
• Time
• Pulse value

Technical specifications

Pulse value
Power supply
Battery
Pulse output
Reverse flow monitoring
Max. switching capacity
Pulse duration
Data interface
Address
M-Bus data readout
Telegram 1 (FCB:0)
M-Bus data readout
Telegram 2 (FCB:1)
Protocol of parameter settings
Meter reading
Medium
Billing date
Parameterisation software
Ingress protection
Ambient temperature, operation
Ambient temperature, storage
Ambient humidity
Cable length
Pin assignment
aquadata ® M-Bus
® M-Bus unit can be changed using the parameterisation software.
0
serial number
00000.000 m³
water
31.12.
pre-installed
pre-installed (winter time)
1 litre per pulse
1 litre
max. 1.5 mA
3 V lithium
Open collector
Yes
27 VDC, 27 mA
50 ms
M-Bus
Primary address
Secondary address
extended secondary address
current meter reading, billing date,
next billing date, billing date value,
identification number
as telegram 1
plus values of 12 previous months
Serial no., medium, pulse value,
primary address, meter reading,
date, time, billing date, meter reading
on billing date
00000,000 m 3
Water
31.12
AMBUS ® WIN
IP 68
0 °C to 50 °C
-20 °C to 60 °C
Up to 98 % relative humidity,
condensation permitted
1.5 m, 4 x 0.14 mm 2
M-Bus: white/black
Pulse output: brown (+) / blue (-)
can be set between 1 and 1000 litres
standard load, battery not used
operating life 6 years + 4 years reserve
S0 compatible according to DIN 43864
with compensation
according to EN 13757, 300/2400 baud
0-250
8-digit
with serial no.
value freely settable
water, cold water, hot water freely selectable
freely settable
www.aquametro.com, under Downloads
permanently attached, wires with ferrules
9