Inductors Et Adaptators - GYS POWERDUCTION 110LG Mode D'emploi

Translation of the original instructions
Special feature of the power setting in this mode
As explained, in normal use mode the setting buttons allow you to change the power while in this mode they change
the time setpoint. To change the power without leaving the mode:
1. Press the heating authorization button (2). Its green light goes out.
2. The setting buttons (4) allow you to change the power. Adjust the power.
3. Press button (2) again. Its indicator light comes on again. The setting buttons (4) become the time setting again.
«ACCESSORY CHANGE» MODE
This mode is accessible only if the heating isn't activated (green button switched off).
1. Press the button (10), the pump stops and the LED (9) switches on.
2. Place the lance on its supports and put the cable on the ground (to prevent loss of cooling
liquid).
3. Unscrew the inductor by hand.
4. Depending on the choice of the new inductor: unscrew the adapter with the supplied
wrench and then screw the appropriate adapter back on (max. 7 N.m) or keep the adapter
already in place.
5. Screw the new inductor back on.
6. Press the button again (10).
The pump activates. For 5 seconds, the LEDs display a wait pattern.
If the flow is correct, the machine emits a double «BEEP» and the product is ready to operate.
Otherwise a fault is displayed (refer to the fault code table).

Inductors et Adaptators

The Powerduction 110LG/160LG are delivered as standard with the 32L adapter and the L90 inductor.
The Powerduction 220LG is delivered as standard with the 32L adapter and the L20/B4 inductor.
The other accessories are optional, they allow to extend the heating possibilities to multiple applications.
Discover the
complete range
Adaptators
Inductors
L90
Ref. 059788
L70
Ref. 059771
L180
Ref. 059795
28
POWERDUCTION 110LG / 160LG / 220LG
5
product serigraphy
32L
Ref. 064515
L20/B4
Ref. 067882
L20 ALU GLOVE
Ref. 069114
L180 D80
Ref. 069121
5
S90
Ref. 058927
S180
Ref. 059269
S180/B1
Ref. 064881
EN
Tightening torque max
= 7N
3
4
2
32S
Ref. 064508
S70
Ref. 061569
S20/B1
Ref. 064874
S180/B2
Ref. 064928