Napoleon PRO665-3 Mode D'emploi page 20

20
Problem
Illumination and Side/Rear
EN
burner ignition work fine
but I can't ignite the side
or rear burner, even when
sparking noise occurs
The knob and switch lights
blink eight times with 0.5
seconds intervals and then
turn off.
www.napoleon.com
Possible Causes
The gap between electrodes is too big
or too small
The batteries are low
Solution
Adjust the gap between two prongs of the side
burner electrode when the side burner does not
ignite.
Adjust the gap between the electrode and the
rear burner when the rear burner when the rear
burner foes not ignite
Replace the batteries
N415-0526 SEP 25.20