36
6.3
DOOR REMOVAL / INSTALLATION
EN
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
Remove screen, see "SCREEN REMOVAL" section.
A.
Loosen but do not remove the 3 securing screws from the top retainer and pull retainer away from the
B.
unit, refer to Figure 1.
There are 2 latches on the top of each door, refer to Figure 2.
C.
Using the tool provided, pull the latch forward and upwards, out of the slot in the door, as shown.
D.
Ensure to keep one hand on the door at all times, to prevent it from falling on the fl oor.
When both latches have been released tilt the door forward and out of the bottom door retainer.
E.
Reverse this process to install the door.
F.
FIG. 2
W415-1285 / 04.14.14
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
FIG. 1
LATCHES
WARNING
!
IMPORTANT: Once latches are engaged,
test that the door is secure and will not
fall forward before letting go.
75.1