Napoleon BHD4N Instructions D'installation Et D'opération page 40

40
8. Place log #7 onto the pin located in log #6 and onto the pin in log #5,
as shown in Figure 7.
EN
9. Place log #8 on the hearth pad and let it rest against the notch in the
side of log #7, as shown in Figure 8. HINT: The best view of log #8
is shown in the left side view below.
10. Place log #9 onto the pin located in log #6 and let it rest on the right
side corner hearth pad and then place one pin into log #7, as shown
in Figure 9.
11. Place log #10 onto the pin located in log #7 and let is rest in the
middle of the right side hearth pad, as shown in Figure 10. Place one
pin into log #1, as shown in Figure 10.
12. Place log #11 onto the pin located in log #1 and let is rest on the right
end hearth pad, as shown in Figure 11.
13. Place charcoal lump #12 onto the two pins located in the center of
the burner, as shown in Figure 12.
14. Tear the ember material into small thin pieces and spread evenly on
top of the burner. Ember material will only glow when exposed to
direct fl ame.
15. Sprinkle the charcoal embers around the hearth then place the
charcoal lumps on top of the charcoal embers, as shown below.
NOTE: Do not cover the pilot or burner ports with media or embers.
Do not overfi ll.
W415-1285 / 04.14.14
3
4
12
1
2
11
RIGHT SIDE VIEW
10
6 7
8
5
2
LEFT SIDE VIEW
10
7
6
9
11
1
3
4
Fig. 7
Fig. 8
PIN
PIN
Fig. 9
Fig. 10
PIN
Fig. 11
Fig. 12