Briteq BTX-FALCON Mode D'emploi page 12

ENGLISH
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Every time you turn the unit on, it will show a welcome message on the display and move all the motors to
their 'home' position and you may hear some noises for about 20 seconds. After that the unit will be ready to
receive DMX signal or run the built-in programs.
Electrical installation for two or more units in master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit in
the chain will automatically act as the master, the other units will act automatically as slaves.
 Make sure that all units are connected to the mains.
 The FIRST projector in the line should be set as MASTER! (also refer to the chapter "SETUP MENU -
Show settings – Offline mode"):
 Press the MENU button and select the "Show Settings" submenu
 Select the "Offline Mode" submenu and select "M/S" ("M/S" stands for "master/slave" mode)
 Select the "Show Mode" submenu and choose one of the Shows.
 Done!
Remark1: if there's no output, please make sure to set the first unit in "M/S" mode.
Remark2: if the units don't follow the beats of the music, check on the master if "Sound Trigger" is set to ON
and the "Sound Sensitivity" is set at the desired level. (see chapter "SETUP MENU")
Electrical installation for several units on a DMX line:
The DMX-protocol is a widely used high speed signal to control intelligent light equipment.
You need to "daisy chain" your DMX controller and all the connected light effects with a
good quality XLR M/F balanced cable. To prevent strange behavior of the light effects, due
to interferences, you must use a 90Ω to 120Ω terminator at the end of the chain. Never use
Y-cables to split the DMX-line, instead use a good quality DMX splitter!
Each unit in the chain must have its proper starting address so it knows which commands from the controller
it has to decode.
BRITEQ
®
10/79
OPERATION MANUAL
BTX-FALCON