Briteq BTX-FALCON Mode D'emploi page 5

ENGLISH
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
CONTROL PANEL:
1. STATUS LEDS: leds used to indicate the status of the projector.
DMX
MASTER
SLAVE
SOUND
2. DISPLAY shows the various menus and the selected functions.
3. NAVIGATION BUTTONS:
MENU
DOWN
UP
ENTER
Two button shortcuts make life easier for the installer:
 Press UP & DOWN buttons together: Display turns over 180°
 Press MENU + ENTER buttons for 3sec: the projector resets.
4. OMEGA CLAMP: on the bottom you can insert the included "omega" quick clamp. Just turn the locking
system over 90° to secure the clamp. Always use a safety cable for extra security!
5. DMX IN/OUTPUTS: used for DMX512 linking, you can use good quality balanced signal cables with 3pin
or 5pin XLR-connectors.
6. MAINS FUSE: this fuse only protects the electronics of the projector, mains input/output (7) is not fused.
7. MAINS INPUT / OUTPUT: with PowerCON
daisy chain several units, up to max 16A. Input and output are connected to each other without any fuse.
Hint: Please check our website for special cable assemblies that contain both power (3x1.5mm² with Neutrik
®
PowerCON ) and balanced signal (XLR 3pin) in one cable. Different lengths are available: 1.3m, 3m, 5m and
10m, very convenient!
BRITEQ
®
On DMX input present, blinks during a software update
On Projector works in master mode
On Projector works in slave mode
Flashing Shows audio activity
To enter the setup menu or return to a previous function
To go forward in the menu tree
To go backward in the menu tree
To confirm the selected function
®
3/79
sockets, connect the supplied mains cable here, you can
OPERATION MANUAL
BTX-FALCON