Briteq BTX-FALCON Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH
FIXED GOBOS (GOBO WHEEL2 – CHANNEL 12
Gobo wheel 2 contains 8 standard fixed gobos (gobo size: 31,4mm – image size: 22,0mm)
These gobos can be replace by your own custom gobos, only metal gobos can be used.
Replacing the gobos:
 Switch the projector off, unplug the power cable and wait until the unit is cool.
 Remove the plastic cover of the head using a Phillips screwdriver (PH2)
 Locate the gobo wheel with fixed gobos.
 The gobos are fixed directly in the gobo wheel.
 Remove the gobo gently and replace it by a new one.
 Put the plastic cover of the head back in place using a Phillips screwdriver (PH2)
 Done.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans and ventilation openings should be cleaned
monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
BRITEQ
®
14/79
OPERATION MANUAL
BTX-FALCON

Publicité

Table des Matières
loading

Table des Matières