Rocal G 505 Manuel D'installation Et De Fonctionnement page 19

Are forbidden other fuels, including liquid (sometimes used to start the fire).
The maximum length of the logs should not exceed the length specified in the
technical data according to model (see Table: Technical characteristics).
2.6. Loading and reload fuel. It must take into account the maximum authorised
load of fuel, ensuring that when the recharge. The fuel can't overtake the limit,
taking care not to exceed either in quantity or size to the data specified above
(you can see the Technical Characteristics).
IMPORTANT NOTE:
Interior parts vermiculite SHOULD NOT BE HIT, especially when done
refueling.
If any of these parts are cracked, but is properly placed in your site, does
not alter the proper functioning of NI A POTENTIAL RISK. The device can be
used normally.
These cracks do not pose any manufacturing defects so you do not fall under
warranty.
To make the procedure ignition follow these steps: placing the burden on the
central area of the database from home, open the register primary and secondary
maximum and then fire pledge (USE ONLY FOR THE ELEMENTS TO). Once the
fire is lit, close the primary register to prevent excessive combustion and control
the intensity by the secondary registers (you can see point 2.2. Fire control).
When the fuel load is reduced you will have to recharge considering data
specified above.
2.7. Mechanism blockage. It is compulsory to check any piece because they
might get stuck after a long period of time without using the fireplace.
It is also advisable to review the outdoor air intakes that supply air for combustion,
they should be free of blockage.
2.8. Load opening.
2.8.1. Guillotine opening: in this system, the door moves from down to upwards
and it is useful for loading.
2.8.2. Swing opening (C23). This function is used for the cleaning or changing
glass, seals etc. To open the doors, use specific tool, rocking it on the upper
frame and pulling to the left so the door moves down.
2.9. Cleaning and maintenance.
2.9.1. Glass cleaning. To clean the glass, the apparatus must not be operating.
Do not clean with any liquid either the metal parts of the door or the seal, in order
to prevent damage.
2.9.2. Ash box cleaning. Empty the ash box when the apparatus is totally off.
Watch out hot ash. When doing it, dump the ash into a metal bucket.
The extraction of this tray can be performed by the top (C24) or the bottom (C25).
For this last option, the possibility of acquiring a small door with grid –
in paragraph E-2 Optional complements
- check with your Rocal distributer)
See
Página 19 de 33