Rocal G 505 Manuel D'installation Et De Fonctionnement page 17

− First we must remove the screws that hold it located at the top (C13).
− After removing the screws, the frame can be free and away from the
module.
Once built the home enclosure, we can replace the screws for adjusting the frame
until the frame is fully coupled to the work.
1.11. Inside the appliance.
1.11.1. Placement the pieces of vermiculite inside the appliance. The
vermiculite pieces are placed at the factory. To avoid weight at the time of the
installation of these parts can be removed and, once installation is complete, it
must be replaced (C14, C15,C16,C17,C18).
1.12. Deflected panels assembly.
1.12.1. Upper side plates (C19, C20). These two plates have three shooting
positions to graduate. The factory default to the open position and will graduate as
appropriate.
1.12.2. Lower baffle plates. Below the plates located above the baffle plates are
inferior.
Warning:
To prevent these baffles falling during transportation, are blocked by a piece of
cardboard placed:
- Between the upper and lower plates
- Above the upper baffles (to access through the vent duct).
1.13. Cleaning and maintenance. It is highly recommended an accessible zone
for the leaning of the apparatus, smoke chamber and smokestack.
Página 17 de 33