General Characteristics - Astralpool NanoFiber 67355 Manuel D'installation Et D'entretien

3. GENERAL CHARACTERISTICS:

The filter medium inside the cartridge is a treated nanofiber designed to separate dirt particles as small as
5 microns.
Under no circumstances may the manufacturer be held liable for the assembly, installation or start-up of
the filter, nor for its subsequent handling, or the addition of hydraulic or electric components that have not
already been installed in your facility.
4. INSTALLATION:
The filter should be as close as possible to the pool, but neither the filter nor the power cable should ever be
installed less than 3.5 m away from the edge of the pool, and preferably 0.50 m below the level of the pool's
water surface.Make sure there is drainage available at the place where the filter is to be installed.
It is recommended that the NanoFiber filter be fitted together with an AstralPool selector valve. There is a
manual valve (code 07444) and a basic automatic one (code 57187).
The valve is sold separately.
Nanofiber Filter
If the filter is installed indoors, a correctly sized drain should be installed, to drain off as much water as
possible from the swimming pool, to avoid flooding risks of the premises or adjoining areas. If this is not
done, the filter manufacturer will not be held liable for possible damage to third parties caused by the filter.
Nanofibre is designed to work with clean water at temperatures that do not exceed 35 ºC.
IMPORTANT: Do not use an iron and hemp pipe for the selector valve connection, it is essential to use plastic
accessories and TEFLON tape. Pipe terminals are available threaded fixing in 1 ½ " and 2".
Always leave enough space round the filter in order to perform the necessary examinations and maintenance
during the filter's life.
5. ASSEMBLY:
Follow these indications for a correct assembly of the filter:
1.- Place the filter on a horizontal and clean surface.
2.- Place the filter in its final position. There are three holes at the base of the filter to secure it in place.
The fastenings are not supplied.
3.- Fit the 2" multiport valve (manual code 07444 or automatic code 57187) inside the filter, whilst
ensuring that the seals between the valve and the filter are in the correct position.
Return
Selector valve
Pump
ATTENTION
Suction inlets
Valve
4
Drain
Skimmer