General Characteristics - Astralpool NanoFiber 64837 Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to
be implemented for installation and start-up. Therefore, the installer as well as the user must read the instruc-
tions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Nanofiber Filter follow the instructions provided below:
CHECK THE CONTENT OF THE PACKAGING:
Inside the box, you will find: Nanofiber filter

GENERAL CHARACTERISTICS:

The filter medium inside the cartridge is a treated nanofiber designed to separate dirt particles as small as
5 to 8 microns.
Under no circumstances may the manufacturer be held liable for the assembly, installation or start-up of
the filter, nor for its subsequent handling, or the addition of hydraulic or electric components that have not
already been installed in your facility.
INSTALLATION:
The filter should be installed as close as possible to the swimming pool and preferably at a level of 0,50
metres below the surface of the water in the swimming pool. Make sure there is drainage available at the
place where the filter is to be installed.
We recommend that the nanofiber filter be fitted together with an AstralPool multiport valve (code 07444).
The valve is sold separately.
Nanofiber Filter
If the filter is installed indoors, a correctly sized drain should be installed, to drain off as much water as
possible from the swimming pool, to avoid flooding risks of the premises or adjoining areas. If this is not
done, the filter manufacturer will not be held liable for possible damage to third parties caused by the filter.
Nanofibre is designed to work with clean water at temperatures that do not exceed 35 ºC.
Nanofiber filter cartridge (inside the filter)
Bag of components: Pressure gauge
Return
Selector valve
Pump
ATTENTION
Connections
Operating Instructions
Suction inlets
Valve
2
Drain
Skimmer