This manual basic information on the safety measures to be adopted during insta-
llation, maintenance and start-up. The fitter and the user must therefore read the
instructions before installation and start-up.
The manual can be downloaded as a PDF file from the website: www.astralpool.com
1. GENERAL SAFETY
The following symbols are used in this manual:
DANGER: indicates a dangerous situation that could result in serious injury or death if not avoided.
WARNING: indicates a dangerous situation that could result in serious injury or death if not avoided.
CAUTION: indicates a dangerous situation that could result in serious injury or death if not avoided.
INFORMATION: is used to refer to matters not related to personal injury.
GENERAL SAFETY RECOMMENDATIONS:
DANGER
• Anyone who assembles this unit must have the qualifications required to do so.
• All contact with electric current must be avoided.
• The regulations in force on the prevention of accidents must be observed.
• The installation must comply with the standards of IEC 364-7-702: INSTALLATION.
• The installation must comply with all local and/or national regulations in force.
• The COMPACT UNIT must be disconnected from the power supply whenever any maintenance jobs or the
replacement of spare parts must be carried out.
• Do not handle the unit if you are standing in water.
• This unit MAY NOT BE CONNECTED TO A STANDARD SOCKET.
• This unit MUST BE PROPERLY WIRED. This must be carried out by a specialist in compliance with the regula-
tions in force on electrical safety in the country of installation.
• The power supply to the housing unit must ALWAYS BE PROTECTED BY A 30 Ma RESIDUAL-CURRENT CIRCUIT
BREAKER.
• There must be AN EARTH CONNECTION.
• Use a sufficiently THICK CABLE for the housing's power supply and its distance from the control panel.
• Fit a lock or padlock to prevent children or unauthorized persons from getting into the housing.
• ALWAYS SWITCH THE PUMP OFF WHEN CHANGING THE POSITION OF THE SELECTOR VALVE.
• Do not open the cover of the compact unit if it is likely to be exposed to wind or strong drafts.
• Under no circumstances may the manufacturer be held liable for the assembly, installation or start-up of any
electrical components that have not been made by it.
COMPACT FILTRATION HOUSING -
INSTRUCTION AND MAINTENANCE MANUAL
3