Special Applications; Gfci-Protected Circuit Wire Tracing; Finding Breaks/Opens - Amprobe AT-6010 Mode D'emploi

4. SPECIAL APPLICATIONS

4.1 GFCI-Protected Circuit Wire Tracing: Connecting the AT-6010-T Transmitter to GFCI
Protected Circuits
Connecting the Transmitter to an Energized GFCI protected circuit using a separate ground
method will trip the GFCI protection. Use the following methods to work with GFCI protected
circuits. For a De-energized GFCI-protected outlet that is not tripped, you can connect test leads
directly to the outlet contacts using the De-energized Tip Sensor mode.
Method 1 – Bypass the GFCI circuitry to avoid tripping GFCI:
(for Energized GFCI-protected outlets only)
• Remove the protective receptacle wall plate.
• Using the alligator clip, attach the red test lead to the screw to connect the Energized hot
wire to the receptacle.
• Connect the green test lead using a separate ground method.
• Perform tracing as described in sections 3.1 or 3.2.
Method 2 – Do NOT use separate ground to avoid tripping GFCI:
(for GFCI-protected outlets and breakers)
• Connect the Transmitter with the test leads to the Neutral and Hot wires.
• Perform tracing as described in sections 3.1 or 3.2.
Note: This type of connection causes signal coupling and reduces signal strength. If the signal is
too weak or untraceable, use Method 3.
Method 3 - De-energize the circuit:
(for GFCI-protected breakers)
• Connect the Transmitter directly to the wire as described in section 3.1.
• Perform tracing as described in sections 3.1 or 3.2.

4.2 Finding Breaks/Opens

It is possible to pinpoint the exact location where a wire is broken, even if the wire is located
behind walls, floors or ceilings.
1. Make sure that wire is De-energized.
2. Use the steps described in section 3.1 to connect the Transmitter and perform tracing.
3. For best results, ground all De-energized wires that run in parallel with the black test lead.
Figure 4.2: Locating a break or open
15