Amprobe AT-6010 Mode D'emploi page 18

3. MAIN APPLICATIONS – LOCATING BREAKERS
Figure 3.2c: Connecting Transmitter to Energized working system
Setting up the AT-6010-T Transmitter
1. Press the ON/OFF key to turn on the Transmitter.
2. Verify that the test leads are properly connected. The red LED voltage status light will
illuminate for Energized circuits with a voltage above 30 V AC/DC. If the voltage is
De-energized, the light will be off.
3. HIGH signal mode is automatically activated when Transmitter is turned on.
Using the AT-6010-R Receiver
1. Turn the Receiver on. Tracing mode is automatically activated.
2. Align the groove on the Tip Sensor with the breaker lengthwise (See Figure 3.2d).
3. Scan all breakers in any order to find a breaker with the highest signal. Adjust sensitivity by
pressing + or - on the keypad to show the signal strength near 50 for the breaker with the
highest signal. After any sensitivity adjustment rescan all breakers to find the one with the
highest signal level.
Important note: Differentiation in breaker designs, height and internal contact structure may
affect the precision of breaker identification. For most reliable results, remove the breaker panel
cover and perform a scan on the wires instead of the breakers.
Depending on the detected signal, the Receiver automatically switches to either Energized
De-energized mode, and displays this information on the LCD.
Figure 3.2d: Aligning the Tip Sensor groove with the breaker
14
or