Safety Instructions - ANSMANN ENERGY 4 SPEED Mode D'emploi

EnErgy 4 SPEED
GB
OPErating inStruCtiOnS
FOrEWOrD
Dear Customer,
Thank you for deciding to buy the ANSMANN Energy 4 SPEED charger. These operating instructions will help you
to use all features of your Energy 4 SPEED charger in an optimum way. Please read the operating instructions
carefully before use. We hope you are happy with your new charger.
Your ANSMANN Team

SaFEty inStruCtiOnS

> Please read the operating instructions carefully before using the charger!
> This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety!
> Do not use the device if there are signs of any damage to the housing, mains plug or cable.
Please contact an authorised dealer!
> Only charge either NiMH or NiCd cells. Never mix both battery types. Danger of explosion if other types of
batteries are inserted! Do not charge non-rechargeable batteries!
> Observe polarity (+/-) prior to use!
> Please note that due to the high charging current, use only good quality batteries from a well known brand in
this charger. Using inferior quality batteries could cause damage to the batteries themselves, and/or the
charger, if they are not suitable for fast charging. If unsuitable cells are inserted in the charger, warranty
claims cannot be accepted and the warranty will become void! Only batteries with appropriate capacities may
be charged in the respective switch position:
• "Fast charge": AA min. 2100mAh / AAA min. 800mAh
• "Standard charge": AA min. 800mAh / AAA min. 300mAh
> Keep the charger in a dry place!
> In order to avoid the risk of fire and/or electric shock, the charger must be protected against high humidity
and water!
> Before cleaning the unit, disconnect it from the mains and only use a dry cloth!
> Never attempt to open the device!